![]() ![]() In fact, the crews were able to use the Tru-Tracker system the entire length of the crossing. The planned intersect point was in the tangent of the crossing where both paths were flat and level and could have the Tru-Tracker wire above this point for locating the downhole steering sensors.” We knew we would be more successful in completing the S-curve by having a rig on the exit side. “We decided,” explained Baker, “to use the intersect method due to the projected 8,500-foot length of the crossing and because there was a horizontal S-curve at the exit point of the crossing. Two Vermeer drill rigs were employed on the project: a D1000x90, which bored 5,000 feet, and a D500x500, which bored 4,000 feet. Also, drilling under and adjacent to two major roads required care to prevent the inadvertent fluid returns, so we constantly monitored drilling fluid properties and the amount of fluid we had coming back.” Intersect solution ![]() “Another challenge was working in the public eye, which always brings concerns. “We spent a long time planning and assisting with the design of the project. “A challenge was, of course, the length of the installation and the diameter of the pipe,” said Cory Baker, Hard Rock general manager. The total length of the pipeline is 4.5 miles.ĭirectional drilling was employed on the 8,400-foot portion of the route because it went through the middle of the city of Midland and crossed two major roads. All product will be moved through the pipelines to a Fasken bank battery. The HDD segment is part of a new pipeline that will carry oil, gas and water from wells to be drilled. Project owner was Fasken Oil and Gas and the pipeline contractor was Kingsley Construction Inc. The complex project included an intersect 5,000 feet from the starting side of the installation. Three smaller-diameter flex steel pipes were placed in the larger pipe before it was pulled in. Intrepid Directional Drilling Specialists may also be known as or be related to Intrepid Directional Drilling Specialists and Intrepid Directional Drilling Specialists, LLP.Hard Rock Directional Drilling LLC recently completed an 8,414-foot-long horizontal directional drilling (HDD) installation of 30-inch diameter steel pipe in Midland, Texas. The data presented on this page does not represent the view of Intrepid Directional Drilling Specialists and its employees or that of Zippia. None of the information on this page has been provided or approved by Intrepid Directional Drilling Specialists. While we have made attempts to ensure that the information displayed are correct, Zippia is not responsible for any errors or omissions or for the results obtained from the use of this information. Sources of data may include, but are not limited to, the BLS, company filings, estimates based on those filings, H1B filings, and other public and private datasets. The data on this page is also based on data sources collected from public and open data sources on the Internet and other locations, as well as proprietary data we licensed from other companies. The employee data is based on information from people who have self-reported their past or current employments at Intrepid Directional Drilling Specialists. Zippia gives an in-depth look into the details of Intrepid Directional Drilling Specialists, including salaries, political affiliations, employee data, and more, in order to inform job seekers about Intrepid Directional Drilling Specialists. ![]()
0 Comments
Leave a Reply. |